LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 931 (Engine Controls And Fuel - 6.6L (LMM) - DTC P0016 To DTC P0299) >> DTC P0047 or P0048 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that DTCs P0652, P0653, P0698, P0699, P2564, or P2565 are not set.
  2. Engine running, increase the engine speed to 1,500 RPM and maintain. Command the TC Vane Pos. Ctrl. Solenoid ON and OFF with a scan tool while observing the Vane Position Sensor parameter. The TC Vane Position Sensor parameter should increase to 95-97 percent and decrease to near 0 percent when changing between the commanded states.
  3. Engine running, observe the TC Vane Position Sensor and the Desired TC Vane Position parameters with a scan tool. Slowly increase the engine speed from idle to 2,500 RPM, and slowly return the engine to idle speed. The TC Vane Position Sensor parameter should remain near or equal to the Desired TC Vane Position parameter throughout the engine speed range.
  4. Engine running, observe the TC Vane Position Sensor and the Desired TC Vane Position parameters while increasing the TC vane position in 5 percent increments from 0-100 percent with a scan tool. The parameters should remain within 2 percent of each other during the entire range.
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals