LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 929 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L And 6.2L - DTC P0010 To DTC P230) >> DTC P0106 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. If DTC P0641 or P0651 are set, refer to DTC P0641 or P0651 .
  2. Verify that restrictions do not exist in the exhaust system. Refer to Restricted Exhaust .
  3. Verify that the engine is in good mechanical condition. Refer to Symptoms - Engine Mechanical for the 4.8L, 5.3L, 6.0L and 6.2L engine.
  4. Ignition OFF for 90 seconds, determine the current vehicle testing altitude. Ignition ON, observe the scan tool BARO Sensor parameter. Compare the parameter to the Altitude Versus Barometric Pressure table. The BARO sensor pressure parameter should be within the specified range indicated in the table.
  5. A skewed MAP sensor will also cause the first and second intake manifold models to disagree with the actual MAP sensor measurements. Use the scan tool and compare the MAP Sensor parameter to a known good vehicle under various operating conditions. The readings should be within 3 kPa of the known good vehicle.
  6. Ignition ON, observe the scan tool MAP sensor parameter. Start the engine. The MAP Sensor parameter should change.
    • If the vehicle passes the Circuit System Verification Test, operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records list.
scientia non olet · About LEMON Manuals