LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 920 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Transmission Fluid Cooler Hose/Pipe Connector Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transmission Oil Cooler Pipe Connectors
    GM659002Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install new transmission oil cooler pipe connectors (1 and 2).

    Tighten:  Tighten to 25 N.m (18 lb ft).

  2. Connect the hose to the transmission oil cooler pipe connectors.
scientia non olet · About LEMON Manuals