Tools Required

J 46409  Torque Converter Lifting Handles. See Special Tools .

Fig 1: Torque Converter Restraining Device
Courtesy of GENERAL MOTORS CORP.
CAUTION: The torque converter dry weight is approximately 29 kg (63 lb). To help avoid personal injury and/or property damage:
• Use caution when installing, removing, or moving the torque converter.
• Get help when lifting the torque converter. Assistance from a hoist or another person is required.
• Make sure J 46409 T-handles are installed securely and that any lifting equipment used can properly support the torque converter.
1. Position the transmission so that the front of the torque converter is facing up.
2. If used, remove 4 bolts and 2 shipping brackets, or remove any other torque converter restraining device.
Fig 2: Installing J 46409 Into Torque Converter Lugs
Courtesy of GENERAL MOTORS CORP.
3. Install 1 J 46409  T-handle into a boss on the front of the torque converter. See Special Tools .
4. Install the other J 46409  T-handle into a boss on the front of the torque converter 180 degrees away from the first T-handle. See Special Tools .
CAUTION: Avoid personal injury or property damage when removing or installing the torque converter by seeking an assistant to help lift the torque converter.
5. Remove the torque converter from the converter housing.
6. Place the torque converter on the work table.