LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 920 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Output Speed Sensor Installation (2WD) >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

J 36850  Transjel® Lubricant. See Special Tools .

    Fig 1: Locating Output Speed Sensor (OSS)
    GM1235609Courtesy of GENERAL MOTORS CORP.
  1. Install the vehicle speed sensor O-ring (3) onto the output speed sensor (OSS) (2).
  2. Apply J 36850  to the O-ring (3). See Special Tools .
  3. Install the OSS (2) into the low and reverse clutch housing, 2WD.
  4. NOTE: Refer to Fastener Notice .
  5. Install the vehicle speed sensor bolt (1) into the low and reverse clutch housing, 2WD.

    Tighten:  Tighten the bolt to 12 N.m (108 lb in).