LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 920 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Low and Reverse Clutch Housing Retaining Ring Replacement

Low and Reverse Clutch Housing Retaining Ring Replacement

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Low and Reverse Clutch Housing Retaining Ring
    GM1235405Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: DO NOT replace the retaining ring in the low and reverse clutch housing unless:
    • The retaining ring is damaged.
    • The low and reverse clutch housing is to be replaced.
  1. Position the low and reverse clutch housing (2) on the worktable so that the inside of the cover is facing down.
  2. Remove retaining ring (1).
  3. Install a new retaining ring (1).
  4. Make sure the retaining ring is seated.
scientia non olet · About LEMON Manuals