LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 920 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Input Carrier Assembly Assemble

Input Carrier Assembly Assemble

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Input Carrier Assembly
    GM1218063Courtesy of GENERAL MOTORS CORP.
  1. Position the intermediate internal gear (4) on the work table so that the tang holes are facing up.
  2. Install the input carrier assembly (3) into the intermediate internal gear (4). Make sure the splines are engaged.
  3. Install the retaining ring (2) into the intermediate internal gear so that the input carrier assembly is retained.
  4. Align the tangs of the thrust washer (1) with the tang holes in the intermediate internal gear.
  5. Install the thrust washer onto the intermediate internal gear.
scientia non olet · About LEMON Manuals