Section 915 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2))
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Transmission Fluid Temperature Sensor Specifications
- Fastener Tightening Specifications
- Transmission General Specifications
- Fluid Capacity Specifications
- End Play Specifications
- Low and Reverse Clutch Spacer Plate Selection
- Forward Clutch Backing Plate Selection
- Third and Fourth Clutch Backing Plate Selection
- Reverse Input Clutch Backing Plate Selection
- Oil Pump Rotor and Slide Measurement
- Torque Converter End Play Specifications
- Torque Converter End Play Inspection
- 2-4 Servo Pin Selection
- Range Reference
- Shift Solenoid Valve State and Gear Ratio
- Shift Speed
- Transmission Fluid Pressure Manual Valve Position Switch Logic
- Transmission Range Switch Logic
- Line Pressure
- Component Resistance
- Schematic and Routing Diagrams
- Component Locator
- Automatic Transmission Electronic Component Views
- Disassembled Views
- Component Location
- Automatic Transmission Inline 20-Way Connector
- Automatic Transmission Internal Connectors
- 1-2 Shift Solenoid (SS) Valve, Wiring Harness Side
- 2-3 Shift Solenoid (SS) Valve, Wiring Harness Side
- 3-2 Shift Solenoid (SS) Valve Assembly, Wiring Harness Side
- Automatic Transmission Fluid Pressure (TFP) Manual Valve Position Switch, Wiring Harness Side
- Input Speed Sensor (ISS) Harness
- Pressure Control (PC) Solenoid Valve, Wiring Harness Side
- Torque Converter Clutch Pulse Width Modulated (TCC PWM) Solenoid Valve, Wiring Harness Side
- Torque Converter Clutch (TCC) Solenoid Valve, Wiring Harness Side
- Automatic Transmission Related Connectors
- Diagnostic Information and Procedures