Rear Output Shaft Seal and Bushing Removal

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Transfer Case Rear Output Shaft Seal & Bushing

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Transfer Case Rear Output Shaft Seal NOTE: Refer to Transfer Case Seal Removal Notice .
2	Transfer Case Rear Output Shaft Bushing Tip: Only remove the bushing if faulty. Refer to Transfer Case Rear Half Cleaning and Inspection . Follow the steps below for use of the J 45380 . Install the finger section of the J 45380 in front of the bushing. Install the tube and forcing screw assembly into the finger section. Ensure the forcing screw is backed out. Using a wrench on the forcing screw, remove the bushing. Special Tools: J 45380 Transfer Case Rear Bushing Remover and Installer

Callout

Component Name

Transfer Case Rear Output Shaft Seal

NOTE: Refer to Transfer Case Seal Removal Notice .

Transfer Case Rear Output Shaft Bushing
Tip:

Only remove the bushing if faulty. Refer to Transfer Case Rear Half Cleaning and Inspection .
Follow the steps below for use of the J 45380 .
1. Install the finger section of the J 45380 in front of the bushing.
2. Install the tube and forcing screw assembly into the finger section. Ensure the forcing screw is backed out.
3. Using a wrench on the forcing screw, remove the bushing.

Special Tools:
J 45380 Transfer Case Rear Bushing Remover and Installer