Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Replacement - Front

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Ensure the bearing is installed squarely into the bearing bore.
1	Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly Tip: Ensure the printing on the bearing is facing upward. A suitable adapter is required to use with the J 8092 . Press the bearing until the bearing bottoms on the front case half. Special Tools J 2619-01 Slide Hammer J 8092 Driver Handle J 44737 Shift Rail Bearing Remover

Callout

Component Name

Preliminary Procedure:
Ensure the bearing is installed squarely into the bearing bore.

Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly
Tip:

Ensure the printing on the bearing is facing upward.
A suitable adapter is required to use with the J 8092 .
Press the bearing until the bearing bottoms on the front case half.

Special Tools

J 2619-01 Slide Hammer
J 8092 Driver Handle
J 44737 Shift Rail Bearing Remover