LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 908 (Engine Controls And Fuel - 6.6L (LMM) - Introduction (2 Of 2)) >> Repair Instructions >> Turbocharger Control Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Turbocharger Oil Feed Pipe Banjo Bolt
    GM1335577Courtesy of GENERAL MOTORS CORP.
  1. Remove the exhaust gas recirculation (EGR) valve cooler. Refer to Exhaust Gas Recirculation Valve Cooler Replacement .
  2. Remove the turbocharger oil feed pipe banjo bolt and washer.
  3. Reposition the turbocharger oil feed pipe out of the way.
    4. Fig 2: View Of Turbocharger Vane Control Solenoid Valve & Electrical Connector
    GM1335540Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the engine wiring harness electrical connector from the turbocharger vane control solenoid valve.
    5. Fig 3: View Of Turbocharger Vane Control Solenoid Valve, Bracket & Bolt
    GM1873292Courtesy of GENERAL MOTORS CORP.
  5. Remove the turbocharger vane control solenoid valve bracket bolt (1) and bracket (2).
  6. Remove the turbocharger vane control solenoid valve (3) from the turbocharger.
scientia non olet · About LEMON Manuals