Removal Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the thermostat housing crossover. Refer to Thermostat Housing Crossover Replacement (LMM) .
- Remove the center intake manifold. Refer to Center Intake Manifold Replacement .
- Reposition the fuel hose clamp (1) at the fuel return pipe.
- Reposition the fuel hose clamp (2) at the fuel injection fuel feed manifold.
- Reposition the fuel hose clamp (2) at the fuel injection pump.
- Reposition the fuel hose clamp (3) at the fuel injection pump.
- Remove the fuel hose (1) from the return pipe and iniection pump.
- Remove the fuel hose (4) from the fuel injection fuel feed manifold and injection pump.
- Loosen the left fuel rail fuel feed pipe fittings (1).
- Remove the left fuel rail fuel feed pipe.
- Remove the fuel injection pump bolts (1).
- Remove the fuel injection pump from the block.
Use 2 screwdrivers to work the pump from the block towards the rear of engine keeping the pump straight.
- The fuel injection pump may need to be rotated in order to remove it from the vehicle.
IMPORTANT:
Be careful not to damage any mating surfaces.