LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 908 (Engine Controls And Fuel - 6.6L (LMM) - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose Replacement - Fuel Injection Pump to Fuel Feed Block >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Hose Clamps
    GM1872010Courtesy of GENERAL MOTORS CORP.
  1. Remove the water outlet. Refer to Water Outlet Tube Replacement (LMM) or Water Outlet Tube Replacement (LU3) .
  2. Remove the intake manifold tube. Refer to Intake Manifold Tube Replacement .
  3. Reposition the fuel hose clamp (2) at the fuel injection fuel feed manifold.
    4. Fig 2: View Of Fuel Filter Hoses & Clamps
    GM1872011Courtesy of GENERAL MOTORS CORP.
  4. Reposition the fuel hose clamp (3) at the fuel injection pump.
  5. Remove the fuel hose (4) from the fuel injection fuel feed manifold and injection pump.
scientia non olet · About LEMON Manuals