LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 908 (Engine Controls And Fuel - 6.6L (LMM) - Introduction (2 Of 2)) >> Repair Instructions >> Exhaust Temperature Sensor Replacement - Position 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Exhaust Temperature Sensor
    GM1873512Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the exhaust temperature sensor.

    Tighten:  Tighten the sensor to 45 N.m (33 lb ft).

    2. Fig 2: View Of Exhaust Temperature Sensor Electrical Connector & Chassis Wiring Harness Electrical Connector
    GM1873511Courtesy of GENERAL MOTORS CORP.
  2. Connect the exhaust temperature sensor electrical connector (1) to the chassis wiring harness electrical connector (2).
  3. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
scientia non olet · About LEMON Manuals