LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 908 (Engine Controls And Fuel - 6.6L (LMM) - Introduction (2 Of 2)) >> Repair Instructions >> Exhaust Pressure Differential Sensor Replacement (Pickup) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Exhaust Differential Pressure Sensor, Bracket Bolts & Pipe Assembly Hose Clamps
    GM1873483Courtesy of GENERAL MOTORS CORP.
  1. Position the exhaust differential pressure sensor (2) to the bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the exhaust differential pressure sensor bracket bolts (1).

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  3. Install the exhaust differential pressure sensor pipe assembly hoses to the sensor.
  4. Position the exhaust differential pressure sensor pipe assembly hose clamps (3).
    5. Fig 2: View Of Chassis Wiring Harness Electrical Connector & Exhaust Differential Pressure Sensor
    GM1873482Courtesy of GENERAL MOTORS CORP.
  5. Connect the chassis wiring harness electrical connector (1) to the exhaust differential pressure sensor (2).
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals