Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Charged Air Cooler & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the charge air cooler.
1. Angle in the left side.
2. Slide to the left.
3. Move in the right side.
4. Position bottom insulators in the radiator support.
  NOTE: Refer to Fastener Notice .
Install the charge air cooler bolts.
Tighten: Tighten the bolts to 21 N.m (15 lb ft).
Install the radiator. Refer to Radiator Replacement (4.3, 4.8, 5.3, and 6.0L) or Radiator Replacement (LLM) .
Install the charge air cooler inlet and outlet pipes. Refer to Charge Air Cooler Inlet Pipe Replacement and Charge Air Cooler Outlet Pipe Replacement .