Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

When reusing valve lifters, install the lifters to their original locations.
Each of the 4 valve guide assemblies will contain 2 active fuel management valve lifters and 2 non active fuel management valve lifters.
With the lifters and guides properly installed, cylinders 1, 4, 6, and 7 lifter bores will each contain 2 active fuel management valve lifters.

Fig 1: Exploded View Of Lifter Guides & Lifters

Courtesy of GENERAL MOTORS CORP.

Lubricate the valve lifters (209, 219) and engine block valve lifter bores with clean engine oil.

Fig 2: Inserting Valve Lifters Into Lifter Guides

Courtesy of GENERAL MOTORS CORP.

Insert the valve lifters into the lifter guides.
- Align the flat area (3) on the top of the non active fuel management lifter with the flat area in the lifter guide bore. Push the lifter completely into the guide bore.
- The active fuel management lifters are to be installed into the guide, with the notch in the guide (1) aligned with the raised area (2) of the lifter.

Fig 3: View Of Lifter Guides & Lifters

Courtesy of GENERAL MOTORS CORP.

Install the valve lifters and guide (210) to the engine block.

NOTE: Refer to Fastener Notice .

Install the valve lifter guide bolts (211).
Tighten: Tighten the bolt to 12 N.m (106 lb in).
Install the cylinder head and gasket. Refer to Cylinder Head Replacement - Left Side or Cylinder Head Replacement - Right Side .