LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 906 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Mount Replacement - Right Side (2500 LY6) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal or the crankshaft pulley. Due to the small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will result in a damaged oil pickup unit.

    Fig 1: View Of Engine Mount To Engine Bolts
    GM1701900Courtesy of GENERAL MOTORS COMPANY
  1. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Cover Replacement 
  2. Remove the two lower engine mount to engine bolts (1).
  3. Remove the starter motor. Refer to (Starter Replacement ).
    4. Fig 2: Locating Tab On Engine Block
    GM1963125Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT: DO NOT raise and/or support the engine by the crankshaft balancer or oil pan.
    Fig 3: View Of Engine Mount To Frame Bolts
    GM1701898Courtesy of GENERAL MOTORS COMPANY
  4. Place an adjustable (screw type) jack to the tab (1) located on the engine block.
  5. Remove the engine mount to frame bolts (1).
    Fig 4: View Of Engine Mount To Engine Bolts
    GM1701900Courtesy of GENERAL MOTORS COMPANY
  6. Remove the two top engine mount to engine bolts (1).
  7. Using the adjustable jack, raise the engine slightly until there is enough clearance to remove the engine mount.
    Fig 5: View Of Engine Mount
    GM1701903Courtesy of GENERAL MOTORS COMPANY
  8. Remove the engine mount.
scientia non olet · About LEMON Manuals