LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 906 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Block Valley Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Valley Cover & Gasket
    GM1403316Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement (L92 - First Design)  or Intake Manifold Replacement (L92 - Second Design)  or Intake Manifold Replacement (LY2 and LY6)  or Intake Manifold Replacement (LH6, LMG, LY5 and L76) .
  2. Remove the engine valley cover bolts (506).
  3. Remove the engine valley cover (555) and gasket (556).
  4. Remove the O-ring seals (537) from the cover.
    5. Fig 2: View Of Oil Pressure Sensor & Washer
    GM1403317Courtesy of GENERAL MOTORS CORP.
  5. Remove the oil pressure sensor (706) and washer (707).
scientia non olet · About LEMON Manuals