LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 905 (Wheel Drive Shafts) >> Repair Instructions >> Wheel Drive Shaft Seal Cover Replacement >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seal Cover, Clamps & Nylon Strap
    GM404258Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Be careful when removing the clamps to avoid damaging the halfshaft seal cover.
  1. Use side cutters to cut the halfshaft seal cover clamps (2) and the nylon strap (1).
    2. Fig 2: Seal Cover
    GM211901Courtesy of GENERAL MOTORS CORP.
  2. Slide the halfshaft seal cover (1) off of the halfshaft, over the CV joint end.
  3. Check the halfshaft seal cover (1) for rips, tears, worn spots or other damage. Reuse the halfshaft seal cover (1) if there is no damage visible.
scientia non olet · About LEMON Manuals