LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 905 (Wheel Drive Shafts) >> Diagnostic Information and Procedures >> Clunk When Accelerating from Coast

Clunk When Accelerating from Coast

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Clunk When Accelerating from Coast

Step Action Value(s) Yes No
DEFINITION: A clunking noise present when accelerating from coast to drive under load.
1 Check for a loose wheel drive shaft to hub assembly nut.
Is the wheel drive shaft nut loose?
- Go to Step 2  Go to Step 3 
2 Tighten the wheel drive shaft to hub assembly nut to specification.
Is the repair complete?
240 N.m
(177 lb ft)
System OK -
3 Check for a damaged inner CV joint.
Is the inner CV joint damaged?
- Go to Step 4  System OK
4 Replace the inner CV joint. Refer to Wheel Drive Shaft Inner Joint and Boot Replacement .
Is the repair complete?
- System OK -