LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 905 (Wheel Drive Shafts) >> Diagnostic Information and Procedures >> Click Noise In Turns

Click Noise In Turns

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Click Noise In Turns

Step Action Yes No
DEFINITION: Clicking noise while turning in drive under load.
1 Check for worn or damaged outer CV joints.
Are the outer CV joints/seals worn?
Go to Step 2  System OK
2 Replace the outer CV joints/seals. Refer to Wheel Drive Shaft Outer Joint and Boot Replacement .
Is the repair complete?
System OK -