LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 904 (Power Steering System) >> Repair Instructions >> Steering Gear Cylinder Pipe Assembly and Seals Replacement - Off Vehicle >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering gear. Refer to Steering Gear Replacement (Rack and Pinion)  or Steering Gear Replacement (Non Rack and Pinion) .
    2. Fig 1: View Of Cylinder Line Retaining Plate & Bolt
    GM1751420Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Protect the steering gear boots from sharp tools and from the sharp edges of surrounding components.
  2. Remove the power steering gear inlet hose retaining plate bolt (1) and the power steering gear inlet hose retaining plate (2).
    3. Fig 2: View Of Rack & Pinion Gear Assembly, Cylinder Line Assemblies, O-Ring Seals & Valve End
    GM1751427Courtesy of GENERAL MOTORS CORP.
  3. Remove both steering gear cylinder pipes (2) from the steering gear (1).
  4. Loosen both steering gear cylinder pipe fittings (3) on the steering gear (1).
  5. Remove and discard the steering gear cylinder pipe seals (4) from the valve end of the steering gear (5).
scientia non olet · About LEMON Manuals