LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 904 (Power Steering System) >> Repair Instructions >> Power Steering Pump Pulley Replacement (6.6L) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the accessory drive belt. Refer to Drive Belt Replacement .
    2. Fig 1: View Of Power Steering Pump Front Bracket & Bolts
    GM1891140Courtesy of GENERAL MOTORS CORP.
  2. Remove the power steering pump front bracket bolts.
    3. Fig 2: View Of Power Steering Pump Rear Bracket & Bolts
    GM1891139Courtesy of GENERAL MOTORS CORP.
  3. Remove the power steering pump rear bracket bolts.
  4. Pull the power steering pump away from the accessory bracket to gain access to the pulley.
    5. Fig 3: View Of Power Steering Pump Pulley Remover
    GM649303Courtesy of GENERAL MOTORS CORP.
  5. Use the J 25034-C  to remove the power steering pump pulley. See Special Tools .
scientia non olet · About LEMON Manuals