LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 904 (Power Steering System) >> Repair Instructions >> Power Steering Pump Pulley Replacement (6.6L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Pump Pulley Installer
    GM643361Courtesy of GENERAL MOTORS CORP.
  1. Place the power steering pump pulley on the end of the power steering pump shaft.
  2. Install the power steering pump pulley using the J 25033-C  . See Special Tools .
    3. Fig 2: Checking Power Steering Pump Pulley Installed Depth
    GM245012Courtesy of GENERAL MOTORS CORP.
  3. Ensure that the power steering pump pulley (1) is flush against the power steering pump shaft (2) with an allowable variance of 0.25 mm (0.010 in).
  4. Reposition the power steering pump to the accessory bracket.
    5. Fig 3: View Of Power Steering Pump Rear Bracket & Bolts
    GM1891139Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Install the power steering pump rear bracket bolts.

    Tighten:  Tighten the rear bracket bolts to 50 N.m (37 lb ft).

    6. Fig 4: View Of Power Steering Pump Front Bracket & Bolts
    GM1891140Courtesy of GENERAL MOTORS CORP.
  6. Install the power steering pump front bracket bolts.

    Tighten:  Tighten the front bracket bolts to 50 N.m (37 lb ft).

  7. Install the accessory drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals