LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 904 (Power Steering System) >> Repair Instructions >> Power Steering Gear Outlet Pipe/Hose Replacement (Diesel) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Gear & Outlet Hose
    GM1890208Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering gear outlet hose (1) to the vehicle.
  2. Connect the power steering gear outlet hose (2) to the steering gear (1).
    3. Fig 2: View Of Power Steering Components
    GM1890205Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Compress the power steering gear outlet hose clamp (2).
  4. Connect the power steering gear outlet hose (1) to the power steering pump assembly (3).

    Tighten:  Tighten the fitting to 32 N.m (24 lb ft).

  5. Clean any excessive power steering fluid from the vehicle and remove the drain pans.
  6. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals