LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 901 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement (1500) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Knuckle (1500)
    GM1869837Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the wheel drive shaft, if equipped. Refer to Wheel Drive Shaft Replacement (2500) .
  4. Remove the wheel bearing and hub assembly. Refer to Front Wheel Hub, Bearing, and Seal Replacement (1500)  or Front Wheel Hub, Bearing, and Seal Replacement (2500) .
  5. Remove the outer tie rod end from the knuckle. Refer to Steering Linkage Outer Tie Rod Replacement .
  6. Separate the upper control arm from the knuckle. Refer to Upper Control Arm Replacement (1500)  or Upper Control Arm Replacement (2500, 3500) .
  7. Separate the lower control arm from the knuckle. Refer to Lower Control Arm Replacement (1500)  or Lower Control Arm Replacement (2500, 3500) .
  8. Remove the knuckle from the vehicle.
scientia non olet · About LEMON Manuals