LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 901 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Ball Joint Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The following service procedure applies to vehicle equipped with cast iron lower control arms only.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the lower control arm from the vehicle. Refer to Lower Control Arm Ball Joint Replacement .
  4. Place the lower control arm in a vise.
  5. Using a chisel, remove the securing crimps from the ball joint body, if equipped.
  6. Using a press, remove the ball joint from the lower control arm.
scientia non olet · About LEMON Manuals