LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 894 (Engine Controls And Fuel - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement (Extended Cab w/26 Gal Tank) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Level Sensor Electrical Connectors
    GM1854694Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank module. Refer to Fuel Sender Assembly Replacement (Regular Cab w/26 Gal Tank)  or Fuel Sender Assembly Replacement (Extended Cab w/26 Gal Tank)  or Fuel Sender Assembly Replacement (Regular Cab w/34 Gal Tank) .
  2. Disconnect the fuel level sensor wiring pigtail electrical connector (1) from the module cover.
    3. Fig 2: Sensor Clip & Retainers
    GM1854696Courtesy of GENERAL MOTORS CORP.
  3. Remove the fuel level sensor wiring pigtail from under the module clip (2).
  4. Gently push in the fuel level sensor retainers (1), disengaging them from the module reservoir.
    5. Fig 3: Fuel Level Sensor
    GM1854697Courtesy of GENERAL MOTORS CORP.
  5. Slide the fuel level sensor up, in order to remove the sensor from the module slot.
scientia non olet · About LEMON Manuals