LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 894 (Engine Controls And Fuel - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission System Cleaning >> EVAP Cleaning Procedure

EVAP Cleaning Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the EVAP canister. Refer to Evaporative Emission Canister Replacement (Regular Cab w/26 Gal Tank)  or Evaporative Emission Canister Replacement (Extended Cab w/26 Gal Tank)  or Evaporative Emission Canister Replacement (Regular Cab w/34 Gal Tank) .
  2. Turn OFF the main valve on the J 41413-200  . See Special Tools .
  3. Disconnect the hose from the diagnostic station pressure regulator.
  4. Using a section of vacuum hose, connect one end to the diagnostic station pressure regulator.
  5. Connect the other end of the vacuum hose to the canister side of the purge pipe.
  6. Turn ON the main nitrogen cylinder valve and continue to discharge nitrogen for 15 seconds.
  7. If the nitrogen does not dislodge the carbon particles, replace the purge pipe.
  8. Return the EVAP pressure/purge diagnostic station to the stations original condition.
  9. Install a new EVAP canister. Refer to Evaporative Emission Canister Replacement (Regular Cab w/26 Gal Tank)  or Evaporative Emission Canister Replacement (Extended Cab w/26 Gal Tank)  or Evaporative Emission Canister Replacement (Regular Cab w/34 Gal Tank) .
  10. Connect all previously disconnected EVAP pipe connectors.
  11. Lower the vehicle.
  12. Continue with the published service manual diagnostic DTC procedure.
scientia non olet · About LEMON Manuals