LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 894 (Engine Controls And Fuel - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Wiring Harness & Components
    GM1876999Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (7) from the camshaft position (CMP) sensor wiring harness jumper.
  2. Remove the water pump. Refer to Water Pump Replacement (LY6, L76 and L92) or Water Pump Replacement (LH6, LY2, LY5, and LMG) or Water Pump Replacement (LMM) or Water Pump Replacement (LU3) .
    3. Fig 2: View Of CMP Sensor & Bolt
    GM1877007Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor and wiring harness jumper from the engine front cover.
  5. Disconnect the CMP sensor wiring harness jumper from the CMP sensor.
  6. Remove the CMP sensor from the wiring harness jumper.
scientia non olet · About LEMON Manuals