Installation Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the air cleaner by pressing downward until the grommets are seated.
- Connect the engine wiring harness electrical connector (1) to the MAF/IAT sensor.
- Install the air cleaner outlet resonator to the MAT/IAT sensor.
- Tighten the air cleaner outlet resonator clamp (1) at the MAF/IAT sensor.
Tighten: Tighten the clamp to 4 N.m (35 lb in).
NOTE:
Refer to Fastener Notice
.