Circuit/System Testing
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, verify that the driver and passenger door switch heated seat switch parameters display Active while the heated seat switches are pressed.
- If either of the switch parameters are continuously Active or Inactive while the switch is pressed, perform the heated seat switch component test.
- Verify that the MSM driver and passenger seat HVC mode and level parameters are displayed correctly as the heated seat switches are activated through all of the operating modes.
- If the MSM parameters are not displayed correctly replace the MSM.
- If the circuits test normal replace the driver or passenger door module.