Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Side View Of Tyco/AMP Connector

Courtesy of GENERAL MOTORS CORP.

Side view of connector.

Fig 2: Top View Of Tyco/AMP Connector

Courtesy of GENERAL MOTORS CORP.

View of top of connector.

Locate the assist lever and lock on the top of the connector.

Fig 3: Depressing Lock & Pulling Assist Lever

Courtesy of GENERAL MOTORS CORP.

While depressing the lock, pull the lever over and past the lock.

Fig 4: View Of Component Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the connector from the component.

Fig 5: Identifying Locking Tabs

Courtesy of GENERAL MOTORS CORP.

Locate the dress cover locking tabs at the rear of the connector. Use a small flat-blade tool to release the locking tabs. Repeat this procedure for the other locking tab.

Fig 6: View Of Inner Connector & Connector Housing

Courtesy of GENERAL MOTORS CORP.

Once the locking tabs are unlocked, slide the inner connector out of the rear of the connector housing.

Fig 7: Using J 38125-12A (GM P/N 12094429) Tool To Release Terminals

Courtesy of GENERAL MOTORS CORP.

Use the J 38125-12A (GM P/N 12094429) tool to release the terminals by pressing on the tang. See the release tool cross reference in the Reference Guide of the J-38125 to ensure that the correct release tool is used. See Special Tools .
While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.