Rear Bumper Impact Bar End Cap Replacement
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Rear Bumper Impact Bar End Cap Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Remove the center rear bumper step pad. Refer to Rear Bumper Step Center Pad Replacement . |
|
| 1 | Rear Bumper Impact Bar End Cap Bolt
NOTE:
Refer to Fastener Notice
.
Tighten: 25 N.m (18 lb ft) |
| 2 | Rear Bumper Impact Bar End Cap Nut Tighten: 10 N.m (89 lb in) |
| 3 | Rear Bumper Impact Bar End Cap Rivets (Qty: 7) |
| 4 | Rear Bumper Impact Bar End Cap |