Circuit/System Testing
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the C3 harness connector at the turn signal/multifunction switch.
- Ignition ON, verify the scan tool Windshield Wiper Switch parameter is not Switch Fault.
- If Switch Fault, test the windshield wiper switch low signal circuit terminal N for a short to ground. If the circuit tests normal, replace the BCM.
- If all circuits test normal, test or replace the turn signal/multifunction switch.