LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 878 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Spark Plug Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Spark Plug Wires
    GM1707125Courtesy of GENERAL MOTORS CORP.
  1. Remove the spark plug wire from the spark plug.
    1. Twist the spark plug wire boot a 1/2 turn.
    2. Pull only on the boot in order to remove the wire from the spark plug.
    2. Fig 2: View Of Spark Plug And Sparkplug Seat
    GM14824Courtesy of GENERAL MOTORS CORP.
  2. Brush or using compressed air, blow away any dirt from around the spark plug.
  3. Remove the spark plug.

    If removing more than one plug, place each plug in a tray marked with the corresponding cylinder number.

scientia non olet · About LEMON Manuals