LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 878 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Pump Flow Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Pump Flow Control Module
    GM1852056Courtesy of GENERAL MOTORS CORP.
  1. Position the fuel pump flow control module (2) to the vehicle.
  2. Slide the fuel pump flow control module towards the driver side of the vehicle.
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the fuel pump flow control module bolts (1).

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    4. Fig 2: Locating Chassis Wiring Harness Electrical Connector
    GM1852055Courtesy of GENERAL MOTORS CORP.
  4. Connect the chassis wiring harness electrical connector (1) to the fuel pump flow control module.
  5. Install the spare tire and wheel.
  6. Program the fuel pump flow control module. Refer to Control Module References .
scientia non olet · About LEMON Manuals