LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 878 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement (15 Ext/Crew Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Canister Vent Solenoid
    GM1855667Courtesy of GENERAL MOTORS CORP.
  1. Position and install the EVAP canister vent solenoid to the vehicle.
    2. Fig 2: EVAP Vent Solenoid Pipe Quick Connect Fitting, Retainer And Pipe Clip
    GM1855666Courtesy of GENERAL MOTORS CORP.
  2. Slide the EVAP canister vent solenoid onto the bracket towards the rear of the vehicle.
  3. Ensure that the retainer (1) is engaged, securing the EVAP canister vent solenoid.
  4. Connect the EVAP vent solenoid pipe quick connect fitting (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: EVAP Canister Vent Solenoid Clip And EVAP Canister Vent Solenoid Pipe Clip
    GM1855664Courtesy of GENERAL MOTORS CORP.
  5. Connect the chassis wiring harness electrical connector to the EVAP canister vent solenoid.
  6. Install EVAP canister vent solenoid clip (1) to the chassis EVAP line.
  7. Install the EVAP canister vent solenoid pipe to the clip (2) on the chassis EVAP line.
  8. Install the EVAP canister vent solenoid pipe to the clips (3) on the brake pipes.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals