Instrument Panel Electrical Center or Junction Block Replacement - Left Side

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Left I/P Electrical Center/Junction Block

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the instrument panel (I/P) knee bolster. Refer to Knee Bolster Replacement (without RPO SLT) or Knee Bolster Replacement (with RPO SLT) .
1	Left I/P Electrical Center/Junction Block Tip: Disconnect all electrical connections. Release plastic retaining tab to loosen electrical center and maneuver out of I/P area.