LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 876 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the knee bolster. Refer to Knee Bolster Replacement (without RPO SLT) or Knee Bolster Replacement (with RPO SLT) .
  3. Remove the steering column shroud. Refer to Steering Column Shroud Replacement .
  4. With the key installed hold it in the START position.
    5. Fig 1: View Of Lock Cylinder & Allen Wrench
    GM1413814Courtesy of GENERAL MOTORS CORP.
  5. Install an allen wrench into the hole on top of the ignition lock cylinder case.

    Push down on the allen wrench to release the tab on the ignition lock cylinder inside the ignition lock cylinder case.

    6. Fig 2: View Of Lock Cylinder At Lock Cylinder Housing
    GM1413837Courtesy of GENERAL MOTORS CORP.
  6. Slide the ignition lock cylinder out of the ignition lock cylinder case.
scientia non olet · About LEMON Manuals