LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 876 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution .
  1. Remove the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
  2. Remove the ignition/start switch. Refer to Ignition and Start Switch Replacement .
  3. Disconnect the park lock cable from the ignition lock cylinder case.
  4. Disconnect the passlock and key buzzer from the ignition lock cylinder case.
    5. Fig 1: View Of Ignition Lock Cylinder & Screws
    GM1700676Courtesy of GENERAL MOTORS CORP.
  5. Remove the 3 ignition lock cylinder case screws (2).
  6. Remove the ignition lock cylinder case (1) from the vehicle.
scientia non olet · About LEMON Manuals