LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 876 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition & Start Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution .
  1. Remove the knee bolster. Refer to Knee Bolster Replacement (without RPO SLT) or Knee Bolster Replacement (with RPO SLT) .
  2. Remove the theft deterrent module. Refer to Theft Deterrent Module Replacement .
  3. Disconnect the passlock and key buzzer from the ignition lock cylinder case.
    4. Fig 1: Inserting J 42759 Into The Lock Cylinder Housing
    GM1413831Courtesy of GENERAL MOTORS CORP.
  4. Insert release tool J-42759  into the ignition lock cylinder case to release the tabs on the ignition/start switch. See Special Tools .
  5. Pull the ignition/start switch out of the ignition lock cylinder case.
  6. Disconnect the electrical connector from the ignition/start switch.
scientia non olet · About LEMON Manuals