LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 875 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Solenoid Cable Replacement (6.2L w/Auxiliary Battery) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Starter Solenoid Cable
    GM1702991Courtesy of GENERAL MOTORS CORP.
  1. Install the starter solenoid cable to the vehicle.
    2. Fig 2: View Of Battery Cable Components
    GM1702504Courtesy of GENERAL MOTORS CORP.
  2. Install the starter solenoid cable to the positive battery terminal.
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the starter solenoid cable nut (5).

    Tighten:  Tighten the nut to 5 N.m (44 lb in).

  4. Close the starter solenoid cable cover at the positive battery terminal.
  5. Install the starter solenoid cable clip (4) to the A/C evaporator tube.
    6. Fig 3: View Of Solenoid Cable Terminal & Nut
    GM1857420Courtesy of GENERAL MOTORS CORP.
  6. Install the starter solenoid cable terminal (2) to the mega fuse stud.
  7. Install the starter solenoid cable nut (1) to the mega fuse stud.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

    8. Fig 4: View Of Fuse Cover & Connectors
    GM1857176Courtesy of GENERAL MOTORS CORP.
  8. Install the mega fuse cover (3).
  9. Raise the vehicle.
    10. Fig 5: View Of Starter Solenoid Cable & Nut
    GM1699544Courtesy of GENERAL MOTORS CORP.
  10. Install the starter solenoid cable (2) to the starter.
  11. Install the starter solenoid cable nut (1) to the starter.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

    12. Fig 6: View Of Starter Solenoid Cable Clip & Bolt
    GM1702990Courtesy of GENERAL MOTORS CORP.
  12. Position the starter solenoid cable clip to the frame and install the starter solenoid cable clip bolt (2).
  13. Install the starter solenoid cable clip (1) to the wheelhouse panel.
    14. Fig 7: View Of Oil Pan Skid Plate & Bolts
    GM1698083Courtesy of GENERAL MOTORS CORP.
  14. Install the oil pan skid plate and tighten the rear 2 bolts and install and tighten the front 2 bolts.

    Tighten:  Tighten the bolts to 28 N.m (21 lb ft).

  15. Lower the vehicle.
  16. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  17. Connect the auxiliary battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (w/Single Battery)  or Battery Negative Cable Disconnection and Connection (w/Auxiliary Battery)  or Battery Negative Cable Disconnection and Connection (w/Dual Batteries) .
scientia non olet · About LEMON Manuals