Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Generator Battery Jumper Cable

Courtesy of GENERAL MOTORS CORP.

Install the generator battery jumper cable to the vehicle.

Fig 2: View Of Generator Battery Jumper Cable & Components

Courtesy of GENERAL MOTORS CORP.

Install the generator battery jumper cable terminal (4) to the mega fuse stud.

NOTE: Refer to Fastener Notice .

Install the generator battery jumper cable to mega fuse nut (3).
Tighten: Tighten the nut to 9 N.m (80 lb in).
Install the generator battery jumper cable clip (2) to A/C evaporator tube.
Install the generator battery jumper cable clip (1) to the stud.

Fig 3: View Of Mega Fuse Cover

Courtesy of GENERAL MOTORS CORP.

Install the mega fuse cover.

Fig 4: View Of Battery Jumper Cable Terminal, Nut & Bolt

Courtesy of GENERAL MOTORS CORP.

Install the generator battery jumper cable terminal (1) to the generator stud.
Install the generator battery jumper cable nut (2) to the generator.
Tighten: Tighten the nut to 9 N.m (80 lb in).
Position the generator battery jumper cable boot (3).
Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (w/Single Battery) or Battery Negative Cable Disconnection and Connection (w/Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (w/Dual Batteries) .