Removal Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Refer to Battery Disconnect Caution
.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (w/Single Battery) or Battery Negative Cable Disconnection and Connection (w/Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (w/Dual Batteries) .
- Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
- Remove the underhood junction block cover.
- Lift the junction block retainers from the locked position (3) and rotate the retainers to the open position (1).
- Remove the junction block.
- Remove the positive battery cable connector (1) from the underhood bussed electrical center (UBEC).
- Disconnect the positive battery cable (1) from the glow plug control module.
- Remove the mega fuse cover.
- Remove the positive battery cable to mega fuse nuts (1).
- Remove the positive battery cable terminals from the mega fuse studs.
- Remove the positive battery cable clip nuts (2) from the studs on the plenum front panel.
- Remove the positive battery cable clip (1) from the stud on the plenum front panel.
- Remove the positive battery cable clips (1) from the studs on the plenum front panel.
- Remove the positive battery cable from the vehicle.