Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Positive Battery Cable

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable to the vehicle.
Install the positive battery cable terminal to the mega fuse stud.

Fig 2: View Of Positive Battery Cable Channel, Clips & Studs

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable channel at the plenum front panel.
Install the positive battery cable clips to the studs on the plenum front panel.

Fig 3: View Of Starter Solenoid Cable & Nut

Courtesy of GENERAL MOTORS CORP.

Install the starter solenoid cable (1) terminal to the mega fuse stud.

NOTE: Refer to Fastener Notice .

Install the starter solenoid cable nut (2) to the mega fuse.
Tighten: Tighten the nut to 9 N.m (80 lb in).

Fig 4: View Of Mega Fuse Cover

Courtesy of GENERAL MOTORS CORP.

Install the mega fuse cover.

Fig 5: View Of Positive Battery Cable Connector & (UBEC)

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable connector (1) to the UBEC.

Fig 6: View Of Junction Block & Retainers

Courtesy of GENERAL MOTORS CORP.

Ensure the junction block retainers are in the open position (1).
Position and align the junction block to the 4 bracket pivots (2), once the pivots are engaged, push the retainer down into the locked position (3).

Fig 7: View Of Under Hood Junction Block Cover

Courtesy of GENERAL MOTORS CORP.

Install the under hood junction block cover.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (w/Single Battery) or Battery Negative Cable Disconnection and Connection (w/Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (w/Dual Batteries) .