LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 875 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Replacement (6.6L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Negative Battery Cable
    GM1873888Courtesy of GENERAL MOTORS CORP.
  1. Install the negative battery cable to the vehicle.
  2. Raise the vehicle.
    3. Fig 2: View Of Negative Battery Cable, Clip, Wiring Harness Ground & Bolt
    GM1873887Courtesy of GENERAL MOTORS CORP.
  3. Position the negative battery cable (2) to the engine block and position the engine wiring harness ground (4) on top of the negative battery cable terminal.
    4. NOTE: Refer to Fastener Notice .
  4. Install the engine wiring harness ground bolt (3).

    Tighten:  Tighten to bolt to 25 N.m (18 lb ft).

  5. Lower the vehicle.
  6. Install the negative battery cable clip (1) to the positive and negative cable bracket.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (w/Single Battery)  or Battery Negative Cable Disconnection and Connection (w/Auxiliary Battery)  or Battery Negative Cable Disconnection and Connection (w/Dual Batteries) .
scientia non olet · About LEMON Manuals