LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 875 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Disconnection & Connection (w/Single Battery) >> Connect Procedure

Connect Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Battery Disconnect Caution .
IMPORTANT: Clean any existing corrosion from the battery terminal and the battery cable end.
    Fig 1: View Of Battery Cable Components
    GM1702504Courtesy of GENERAL MOTORS CORP.
  1. Position the negative battery cable to the battery.
    2. NOTE: Refer to Fastener Notice .
  2. Install the negative battery cable onto the battery terminal.
  3. Tighten the negative cable nut (6).

    Tighten:  Tighten the nut to 5 N.m (44 lb in).

  4. Close the hood.
scientia non olet · About LEMON Manuals