LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 875 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Disconnection & Connection (w/Dual Batteries) >> Connect Procedure

Connect Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Battery Disconnect Caution .
NOTE: Refer to Fastener Notice .
IMPORTANT: Clean any existing corrosion from the battery terminal and the battery cable end.
    Fig 1: View Of Battery Components
    GM1873941Courtesy of GENERAL MOTORS CORP.
  1. Install the negative battery cable (6) onto the battery negative post.
  2. Tighten the negative battery cable nut (4).

    Tighten:  Tighten the nut to 7.5 N.m (66 lb in).

  3. Close the negative battery cable post cover (3).
    4. Fig 2: View Of Negative Battery Cable & Components
    GM1873940Courtesy of GENERAL MOTORS CORP.
  4. Install the starter solenoid cable onto the battery negative post.
  5. Tighten the starter solenoid cable nut (1).

    Tighten:  Tighten the nut to 5 N.m (44 lb in).

  6. Close the hood.
scientia non olet · About LEMON Manuals